Know for being very good grade of wear resistant engineering plastics is Dupont Extruded Nylon type 66 material. This grade of plastic has been one of the chief mechanical plastics for almost 50 years.
Natural Extruded Nylon type 6 material
Dupont Nylon is well known for being wear resistant. Nylon is the preferred material for important products like pulleys, slide ways, chute impact points and chain guides. If you are looking for a wear resistant material simply click here, %LINK%
This exceptional material excels with extended use and are typical when using Nylon. Nylon has one of the widest ranges of sizes and shapes, including small extrusions to massive castings. The Dupont Black Extruded Nylon type 6 are readily available.
Between the Delrin and POM-C rods, both materials are quite tough and easily machinable, and they have very similar physical properties. They do appear similar, but in practical uses there are some differences that may make one preferable than the other. It also depends heavily on your application. As with any plastic materials, make sure to check the typical properties data sheet for the applicable properties you may need for your application.
תגובות
הוסף רשומת תגובה